Killerglass Support & Knowledge Base


Knowledgebase
Killerglass Online Store > Killerglass Support Desk > Knowledgebase

Basic Installation Cars

Solution Installing Killerglass is quite easy using common hand tools along with a heat gun or hair dryer to seal the Gates Power grip heat shrink clamps.

Installation involves draining a small amount of antifreeze from your car which is easily done by removing the radiator cap then opening the petcock at the bottom of the radiator (no tools needed, opens by hand) Place a clean drain pan or bucket to catch what antifreeze comes out. Drain about a gallon, just enough to get the level below the upper hose. Then close petcock.

Place glass hose where it fits in place next to the correct radiator hose, mark the hose where it is to be cut. Best to cut it slightly less then needed and after positioning it correctly cut the remaining of the hose as necessary (tool required, scissor, sharp knife or hose cutter).

Slide heat shrink clamps over the rubber hose where the Killerglass fits inside it and take your heat gun or hair dryer and shrink them for 5 minutes or until they are totally seated. Attach LED to Killerglass, attach power leads to a switch connected to the battery as you would any other LED.

Refill radiator with what you took our, start engine and let it come up to temperature to check for any leaks.


Download our instructions in WORD format

Attachments:
Basic_Installation_Instructions_Cars.zip Basic_Installation_Instructions_Cars.zip

Article details
Article ID: 2
Category: Installing Killerglass
Date added: 2010-11-14 15:13:52
Views: 871

 
<< Go back

Powered by Help Desk Software HESK™